mapp Vision 需要在 POWERLINK 以太网网络中运行 IP 通信才能实现摄像机功能。可能需要摄像机的 IP 地址。该地址由 mapp Vision 生成，包括摄像机所连接控制器的 POWERLINK 接口以太网 IP 地址的前 3 个字节和摄像机的节点编号（第 4 个字节）。

例如如果 POWERLINK IP 地址为 "168.192.200.240"，节点号为 "5"，则摄像机 IP 地址为 "168.192.200.5"。

有关其他信息和相应示例，请参阅第页配置 POWERLINK 以太网。

POWERLINK 接口的以太网 IP 地址

用户可在控制器的 PLK 接口配置中配置 POWERLINK 接口的以太网 IP 地址。在物理视图中，右键单击 PLK 接口并从列表中选择 "Configuration（配置）"，即可打开配置。该参数位于 <IF3><运行模式><以太网参数><冗余参数><模式>。

节点编号

摄像机节点号也可以在物理视图中找到。在硬件树的 "位置 "列中，缩写 "ST "后面的数字与节点编号相对应。

mapp Vision requires functioning IP communication in the POWERLINK Ethernet network for the camera function. The IP address of the camera may be required. This is generated by mapp Vision and consists of the first 3 bytes of the Ethernet IP address of the POWERLINK interface for the controller to which the camera is connected and the node number of the camera for the fourth byte.

Example: If the POWERLINK IP address is "168.192.200.240" and the node number is "5", then the camera IP address will be "168.192.200.5".

For additional information and corresponding examples, see page Configuring POWERLINK Ethernet.

Ethernet IP address of the POWERLINK interface

The Ethernet IP address of the POWERLINK interface can be configured by the user in the PLK interface configuration of the controller. The configuration can be opened in the Physical View by right-clicking on the PLK interface and selecting "Configuration" from the list. The parameter is located at <IF3><Operating mode><Ethernet parameters><Redundant parameter><Mode>.

Node number

The camera node number can be also be found in the Physical View. In column "Position" in the hardware tree, there is a number after abbreviation "ST" that corresponds to the node number.