线路传感器选项卡
选项卡 "线路传感器 "包含用于图像采集的参数和过程变量，这些参数和过程变量仅适用于配置线路传感器。有关单个参数的信息，请参阅图像采集配置（非循环写入）。
全图像采集模式
图像上方的 "图像模式 "选项卡包含以下按钮：
此按钮可用于使用带活动线路传感器的摄像机获取正常尺寸的图像。方法是启用该按钮，然后触发图像。要返回到通过线性传感器获取图像的模式，必须禁用该按钮。
正常图像模式旨在简化照明参数的配置和线条传感器行的定位。
在定位行时，移液管也会有所帮助，因为它不仅可以用来识别像素的灰度值，还可以用来识别像素在图像中的位置。
mapp Vision HMI 应用程序不支持动态线条传感器（请参阅线条传感器模式）。可将线性传感器配置为静态配置，或在 I/O 接口上指定有效值（CyclicLineScanNettime和CyclicLineScanPeriod）。
Tab line sensor
Tab "Line sensor" contains parameters and process variables for image acquisition that are only available for and needed to configure the line sensor. For information about individual parameters, see Image acquisition configuration (acyclic write).
Full image acquisition mode
Tab "Image mode" above the image contains the following button:
This button can be used to acquire a normal-sized image using a camera with an active line sensor. This is done by enabling this button and then triggering an image. To go back to acquiring images via the line sensor, the button must be disabled.
Normal image mode is meant to simplify the configuration of lighting parameters and the positioning of the line sensor row.
When positioning the row, the pipette may also be helpful since it can be used to identify not just the grayscale value of the pixel, but also the pixel's position in the image.
The dynamic line sensor (see LinesensorMode) is not supported on the mapp Vision HMI application. The line sensor can be configured as static for the configuration, or valid values must be specified on the I/O interface (CyclicLineScanNettime and CyclicLineScanPeriod).